Encoder manufacturers-Roundss-how to use encoder！

Encoder manufacturers-Roundss-how to use encoder
The encoder as electronic product parts, in the course of some of the problems that need attention. Encoder functions through cooperation with IC, played increment, decrement, flip and other functions. The encoder mainly used for volume, frequency, temperature, measure, speed adjustment and menu selection. Here Changchun Rongde Optics-encoder manufacturer- would tell you what is to paid attention when using encoders.

Due to thermal stress will change, so please confirm in advance sufficient welding conditions
1. circuit board through-hole printed circuit board and are not recommended.

2. The belt-positioning, in the positioning position welding. If the weld at the mid-point positioning is fixed, the positioning mechanism may be deformed.

3. Do not wash encoder parts

4. With regard to vibration terms, applied to the rotary encoder vibration, they tend to be the reason for the error pulse generation. Therefore, to deal with the installation location, the installation site attention.

5. In combination component mounting process, special attention not to apply force to the small, thin switch.

6. Tighten the mounting bolts, to be carried out within a predetermined strength, the strength exceeds the specified may cause malfunction or damage to the bolt portion.

7. If the voltage or current 10UA less VC1V the following, there will be the possibility of poor contact.

8. If and power lines, power lines off the line wiring, the sensor may be subject to damage caused by a malfunction, so to separate separate wiring.

Between the encoder housing and the control panel box potential difference may malfunction due to noise, in this case, we need to use a certain distance between the two then wire connections.

Previous：Rotary encoder wiring-Roundss Encoder
Next：Defination of encoder and electronic circuits of encoder